Washing - Vector e-bike Manual

Washing

Regular cleaning of your Vector is recommended to extend its lifespan and to ensure proper
performance.
You must be careful not to damage any of the components. In order to do so we recommend:
Before cleaning, check that all electrical components are properly connected and the vehicle is turned
off.
DO NOT use a pressure washer or steam appliances that may cause the water to penetrate the seals,
bearings and power components. We recommend applying soap with a soft sponge.
DO NOT directly wet any of the electrical power parts or controls/connectors located on the
handlebar. You can use a damp cloth to clean these areas.
The plastic parts should be washed with a soft sponge and soap. Never use abrasive products,
solvents, or products that may scratch or damage them.
After washing, dry the vehicle with a clean dry cloth.
Once finished, wait until your Vector is completely dry before using it.
After cleaning and before using the vehicle, try the brakes. Apply pressure to both brakes several
times to remove the humidity in the pads.