Wheel Change - Vector e-bike Manual

Wheel Change

REMOVING THE FRONT WHEEL
BEFORE ANY OPERATION, ENSURE YOUR VECTOR IS TURNED OFF.
Put the bike on soft support so the front wheel stays in the air.
Whenever the Moto-Bike is with the side stand unfolded, the vehicle must not be moved backwards.
Otherwise, the pedal may cause the shock between the connecting rods and the side stand pick up
springs, causing damage to the connecting rod and springs. The recommended position would be,
leaving the pedal just in front of the side stand. In this way, the maximum safety margin will be
reached, before crushed the connecting rod with the side stand unfolded.
Loosen the nuts from the wheel shaft slightly (1) with a 10 Allen key until both have been disengaged
a few millimeters from the shaft. Remove one of the nuts completely.
Loosen the 4 bolts from the bottom of the fork (2) with a 5 Allen key (they do not need to be removed
completely).
Hold the wheel by pulling it slightly upwards so that the axle stops supporting all of its weight. Hold
the axle by the nut that was not removed (3) and pull to remove it completely from its housing.
WHEN YOU MOUNT THE WHEEL BACK YOU SHOULD BE CAREFUL WHEN INSERTING THE DISC
BETWEEN THE PADS OF THE BRAKE CALIPER.