Right Side Panel - MTD Cub Cadet 221 HP Manual

Figure 4.35

Right side panel

Figure 4.36
Figure 4.37
Auger Housing Components
5.Remove the idler arm by following the procedures
described in Chapter 3: Auger, Belt and Pulleys.
6.Remove the five screws (indicated by the arrows) that
attach the side panel to the blower housing using a 3/8"
wrench. See Figure 4.35.
7.Slide the side panel off of the auger shaft.
8.Install the side panel by following the previous steps in
reverse order.
NOTE: Tighten the bearing retainer screws to a torque of
70 - 100 in lbs (8 - 11 Nm).
9.Test run the snow thrower in a safe area before returning
it to service.
To remove/replace the right side panel:
1. Remove the screw and washer that attach the right
auger bearing to the auger shaft. See Figure 4.36.
2. Remove the two screws that secure the bearing
retainer to the side panel using a 3/8" wrench.
3. Remove the five screws (indicated by the arrows)
that hold the right side panel to the auger housing
using a 3/8" wrench. See Figure 4.36.
4. Gently pry the bearing out of the auger housing.
See Figure 4.37.
NOTE: There is a metal ring on the bearing that prevents
the bearing from sliding through the opening of the
side panel. It is part of the bearing, do not try to
remove it.
5. Slide the side panel off of the auger shaft.
6. Install the side panel by following the previous steps
in reverse order.
NOTE: Tighten the bearing retainer screws to a torque of
70 - 100 in lbs (8 - 11 Nm).
7. Test run the snow thrower in a safe area before
returning it to service.
41