Table of Contents
Advertisement
Unpacking & Assembly
Unpacking
After removal from the carton please check that you have been supplied with the
following main parts.
1.
The main frame with front castors attached.
2.
Foot rigging:
3.
Rear drive wheels:
Assembly
Please assemble the main parts mentioned as per the following procedure and check the
assembly for normal operation.
1.
Mount the swing away legrests as shown in Fig 8.
2.
Install the two rear drive wheels as shown in Fig 9 / 10 / 11.
General Operation
1.
Hold the two armrests with your hands as Fig 13 shows.
2.
Extend the armrests outwards as Fig 14 shows.
3.
Push down on the seat rails to ensure the seat opens fully and locks into the
receivers on the wheelchair side frames as Fig 15 shows.
4.
Swing the legrests around to the front of the chair and ensure that they lock
into place.
To fold the wheelchair for storage or transportation
1.
Fold up the foot plates and unlock the levers which position the legrests.
Swing the foot plates and legrests away. Either leave the foot plates in this
position or remove them completely by lifting each legrest vertically to clear
the pivot bush as Fig 16 shows.
2.
Take hold of the centre of the seat upholstery, one hand at the front and the
other at the rear, pull the seat upholstery up vertically as Fig 18/19 shows.
3.
The rear drive wheels can be removed if required. This Invacare chair is
supplied
with quick release axles, to remove the drive wheels simply hold the
wheel and
depress the large button in the centre of the axle. Whilst the release button is
depressed withdraw the axle and remove the wheel as Fig 11 shows.
Invacare Coastlite Manual Wheelchair Owner's Manual – page 8. May 2003
C650
Swing away & detachable legrests
C650
24" x 1-3/8" Spoke wheels
Advertisement
Table of Contents
