Table of Contents
Advertisement
1.3.3
Designations
In this documentation, the following designations are used:
Table 4: Designations
Designation
Meaning
HD 2/H
Lift-rotate unit from the Rexroth transfer system TS 2plus
WT 2
Workpiece carrier from the Rexroth transfer system TS 2plus
BG
Size
2 Safety instructions
2.1 About this chapter
The product was manufactured in accordance with generally accepted engineering
standards. Nevertheless, there is a risk of personal injury and property damage if you
do not observe this chapter and the safety instructions in this document.
Read this manual thoroughly and completely before you start working with the
product.
Keep the documentation accessible to all users at all times.
When passing on the product to a third party, make sure that it is always
accompanied by the necessary documentation.
2.2 Intended use
The product is an incomplete machine.
You may use the product as follows:
• for installation in a Rexroth transfer system TS 2plus
• For lifting and rotating Rexroth-workpiece carriers WT 2 from the conveyor
section.
• Maximum load / line load: See technical data on page 51.
• For the environmental conditions see page 54.
The product is strictly intended for professional use and not for private use.
The intended use also implies that you have read and understood this
documentation, especially chapter 2 "Safety".
2.3 Improper use
Any other use than that which is described as the intended use is improper and not
permitted.
Bosch Rexroth AG is not liable for damage resulting from improper use. The risks
associated with improper use lie solely with the user.
The following also fall under the category of improper use:
• Transporting other transport materials than those which are specifi ed.
• The use of the product without protective case or other protective guard on the
premises.
• Operating the product in accumulation mode.
Safety instructions
3 842 358 796/2015-01, MIT: HD 2/H, Bosch Rexroth AG
7/56
Advertisement
Table of Contents
