Polaris RZR Trail S 2022 Owner's Manual page 186

TROUBLESHOOTING
POSSIBLE CAUSE
Poor engine
performance
Slippage from failure to
warm up belt
Wrong or missing belt
Improper break-in
Failed belt
ENGINE DOESN'T TURN OVER
POSSIBLE CAUSE
Low battery voltage
Loose battery connections
Loose solenoid connections
Loose electronic control box
connections
Mechanical failure
184
Check for fouled plugs or foreign material in gas
tank or fuel lines. See your dealer.
Always warm up the belt by operating below 30
mph (48 km/h) for 1 miles (1.5 km) and for 5 miles
(8 km) or more when temperature is below
freezing.
Install the recommended belt.
Always break in a new belt and/or clutch. See the
Vehicle Break-in Period section for details.
Remove the belt and clean away any debris from
the clutch box, clutch duct and engine
compartment. Install a new belt.
WARNING! Failure to remove ALL debris when
replacing the belt could result in vehicle damage
and severe injury or death. See the Belt
Replacement / Debris Removal section for details.
Recharge the battery to 12.8 VDC
Check all connections and tighten
Check all connections and tighten
Inspect, clean, reinstall connectors;
blow on EFI fuse to remove impurities
Your POLARIS dealer or other
qualified person can assist.
SOLUTION
SOLUTION