Polaris RZR Trail S 2022 Owner's Manual page 137

OIL AND FILTER CHANGE
Always change the oil and filter at the intervals outlined in the Periodic
Maintenance Chart section. Always change the oil filter whenever changing oil.
Access the oil check dipstick and oil filter through the engine access panel
located behind the seats.
The crankcase drain plug is located on the bottom of the crankcase. Access the
drain plug through the access hole under the crankcase.
1. Position the vehicle on a level surface. Place the transmission in PARK.
2. Clean the area around the crankcase drain plug.
Hot oil can cause burns to skin. Do not allow hot oil to contact skin.
3. Place a drain pan under the engine crankcase and remove the drain plug.
Allow the oil to drain completely.
4. Remove the seats and remove the engine access panel.
5. Using an oil filter wrench, turn the filter
6. Using a clean dry cloth, clean the filter sealing surface on the crankcase.
7. Lubricate the o-ring on the new filter with a film of fresh engine oil. Check to
make sure the o-ring is in good condition.
8. Install the new filter and turn by hand until the filter gasket contacts the
sealing surface, then turn an additional 3/4 turn.
9. Reinstall the crankcase drain plug. Torque to 12 ft-lbs (16 N·m).
10. Remove the oil fill cap and add 2.5 qt (2.4 L) of recommended oil (listed in
the Oil Recommendations section). Reinstall the fill cap.
11. Start the engine and check for leaks.
12. Stop the engine and wait 15 seconds before removing the dipstick.
13. Remove the dipstick. Wipe it dry with a clean cloth.
CAUTION
q
counterclockwise to remove it.
MAINTENANCE
135