Table of Contents
Advertisement
SETUP
3B
USB Setup
To connect the Diva 2430 via the USB port, your computer must be running Windows 98, Windows 98SE,
Windows 2000, or Windows Me. For other operating systems, see 'Ethernet Setup' on page 4.
Leave your computer on during the installation. Once you connect the Diva 2430 to your computer, Windows will
automatically detect the device and request device driver information (provided on the Diva 2430 CD-ROM).
Use the diagram below as a guide to connecting the cables. Do not connect the same computer to both ports.
Insert the Diva 2430 CD-ROM into your
1.
CD-ROM drive.
Connect the Diva 2430 to an electrical outlet using
2.
the power adapter. The power connector is labelled
on the Diva 2430.
Connect the Diva 2430 to your ADSL telephone
3.
outlet (RJ11) using the supplied ADSL cable. The
ADSL port is labelled
After several seconds, the ADSL light on the front
panel will flash to indicate that the Diva 2430 is
attempting to establish an ADSL connection.
When the ADSL light stops flashing and stays on,
the ADSL connection has been established. If the
ADSL light continues to flash, the Diva 2430 is
having difficulty establishing the ADSL
connection.
Note: Do not install a microfilter between the Diva 2430
and the telephone jack.
Connect the flat end of the USB cable into any
4.
available USB port on your computer, then plug
the other end into the Diva 2430's USB port. The
USB port is labelled
ADSL
USB
Cable
Cable
on the Diva 2430.
on the Diva 2430.
Power
Adapter
Once the USB cable is connected, the 'New
5.
Hardware Found' window appears, followed by
the 'Add New Hardware Wizard' window.
Click 'Next' to begin.
6.
Select 'Search for the best driver for your device',
7.
then click 'Next'.
Select 'Specify a location' and clear other options.
8.
Click 'Browse'. Go to the 'USB' folder on the
9.
Diva 2430 CD-ROM.
• If you have Windows 98, select 'WIN98'.
• If you have Windows 2000, select 'WIN2000'.
• If you have Windows Millennium Edition, select
'WINMe'.
Click 'OK', then click 'Next'.
10.
Click 'Next' to begin installation of the driver.
11.
Note: You may be asked to insert your Windows
installation CD-ROM while the driver is being installed.
Once installation is complete, click 'Finish'. If you
12.
are asked to restart your computer, do so.
5
What's Next?
Go to 'Surf!' on page 6.
Advertisement
Table of Contents
