Toro SnowMaster Manual page 33

Jackshaft Removal and
Replacement (Figure 54)
Removal
1. Remove the belt covers, belt, and transmission from
the unit.
2. Place a screw driver or similar tool through the hole
in the jackshaft (Figure 55).
Figure 55
3. Remove the bolt securing the jackshaft/rotor pulley
(item 4). Remove the pulley (Figure 56).
Figure 56
Toro® - SnowMaster® Service Manual
4. Inside the housing, remove the bolts securing the
other jackshaft pulley (item 4). Remove the pulley
(Figure 57).
Figure 57
5. Remove the three bearing retainer bolts from inside
the belt housing (Figure 58).
Figure 58
6. Remove the three bearing retainer bolts form the
side of the housing. Remove the bearing retainer
(Figure 59).
Figure 59
Table of Contents
CHASSIS
3-19