Toro SnowMaster Manual page 32

CHASSIS
Rotor and Rotor Drive
6
2
1. Rotor-Pulley Asm.
2. Rotor Clutch Asm.
3. Flat Idler-Pulley
4. Rotor Jack shaft-Pulley
5. V Poly-Belt
6. Extension Spring
1
Lubricate idler arm, on both sides around pivot hole
with grease.
2
Spring must be assembled as shown, it must pass
through both the slot and hole in spring clip.
3-18 Table of Contents
2
1 4
1
3
Figure 54
3
Extended pulley hub must be assembled towards the
rotor.
4
Ensure idler arm, pivots freely after assembly.
Toro® - SnowMaster® Service Manual
4
3