Toro SnowMaster Manual page 19

Chute and Shroud Removal &
Replacement (Figure 13 and 14)
Removal
1. Remove RH (item 11) and LH (item 10) upper
shrouds..
2. Remove the bolt and nut attaching the chute post
(Figure 13) (item 4). Remove the post and chute
assembly.
NOTE: Must remove the quick stick rod and
deflector cable clamp on the side of the
frame on QS models prior to removing the
chute assembly.
3. Remove the screws that hold the lower chute (item
1) to the housing kicker. (item 12)
4. Tip the unit forward. Remove the lower chute (item
1) bottom screws (Figure 15).
Figure 15
5. Remove the lower chute (item 1) from the unit.
Toro® - SnowMaster® Service Manual
Replacement
1. Install the lower chute (item 1). Install the lower
chute bottom screws and the screws that hold the
lower chute to the housing kicker (item 12). Torque
screws to 25-35 in-lbs. (2.8-4 Nm) (Figure 16).
Figure 16
2. Install the chute post (item 3) and chute assembly.
Torque to 60 in-lbs. (7 Nm) (Figure 17).
NOTE: Must insert the quick stick rod and
deflector cable clamp on the side of the
frame on the QS models prior to installing
the chute assembly.
Figure 17
3. Install the RH (item 11) and LH (item 10) upper
shrouds. Torque screws to 25-35 in-lbs. (2.8-4 Nm).
Table of Contents
CHASSIS
3-5