Default - Factory Settings - Macurco TX-6-HS User Instructions

3. With the 4-20 mA function turned "On" and the H2S concentration climbing the 4-20 mA signal will ramp up corresponding to
the concentration (0-50 ppm).
Default Configuration – Factory Settings

The default Power Up Test setting is On

The default Display setting is OFF

The default Buzzer setting is OFF

The default Alarm Relay Setting is activation at 20 ppm

The default Alarm Relay Configuration is Normally Open

The default Fan Relay Setting is activation at 8 ppm

The default Fan Relay Delay setting is 3 minutes

The default Fan Relay Runtime setting is 0 minutes

The default Fan Relay Latching condition is OFF

The default Trouble Fan Setting condition is OFF

The default 4-20mA Output setting is On
To change settings, remove the Philips screw on the front of the TX-6-HS. Pull off the front cover of the unit.
13