Explanation Of Symbols And Safety Instructions; Explanation Of Symbols; General Safety Instructions; Regulations - Bosch Compress 7001i AW Installation Manual

1

Explanation of symbols and safety instructions

1.1

Explanation of symbols

Warnings
In warnings, signal words at the beginning of a warning are used to
indicate the type and seriousness of the ensuing risk if measures for
minimizing danger are not taken.
The following signal words are defined and can be used in this document:
DANGER
DANGER indicates that severe or life-threatening personal injury will
occur.
WARNING
WARNING indicates that severe to life-threatening personal injury may
occur.
CAUTION
CAUTION indicates that minor to medium personal injury may occur.
NOTICE
NOTICE indicates that material damage may occur.
Important information
The info symbol indicates important information where there is no risk to
people or property.
Additional symbols
Symbol Meaning
▶ a step in an action sequence

a reference to a related part in the document
• a list entry
– a list entry (second level)
Table 1
1.2

General safety instructions

These installation instructions are intended for
plumbers, heating system installers and electricians.
▶ Read all installation instructions (heat pump,
control system etc) carefully before installation.
▶ Follow safety and warning instructions.
▶ Follow national and regional regulations, technical
regulations and guidelines.
▶ Document all work that has been performed.
H Intended operation
This heat pump is intended to be used in a closed
heating system for households. All other use is
considered unsuitable. Any damage that is caused by
such usage is excluded from liability.
Compress 7001i AW – 6721835318 (2021/09)
Explanation of symbols and safety instructions
H Installation, commissioning and service
The heat pump may only be installed, brought into
operation and maintained by authorised personnel.
▶ Use only original spare parts.
H Electrical work
Electrical work may only be performed by authorised
electrical installers.
Before commencing work:
▶ Disconnect mains voltage on all poles and ensure it
cannot reconnect.
▶ Check to ensure that the power is disconnected.
▶ Also check the connection diagram for other parts
of the system.
H Handover to the user
When handing over, instruct the user how to operate
the heating system and inform the user about its
operating conditions.
▶ Explain how to operate the heating system and draw
the user's attention to any safety relevant action.
▶ In particular, point out the following:
– Modifications and repairs must only be carried
out by an approved contractor.
– Safe and environmentally compatible operation
requires inspection at least once a year and
proper cleaning and maintenance.
▶ Point out the possible consequences (personal
injury, including danger to life or material damage)
of non-existent or improper inspection, cleaning
and maintenance.
▶ Leave the installation instructions and the
operating instructions with the user for
safekeeping.
2

Regulations

This is an original manual. This manual may not be translated without the
approval of the manufacturer.
Follow the directives and regulations given below:
• Local provisions and regulations of the electricity supplier and
corresponding special rules
• National building regulations
• F-Gas regulation
• EN 50160 (Voltage characteristics of electricity supplied by public
electricity networks)
• EN 12828 (Heating systems in buildings - Design for water-based
heating systems)
• EN 1717 (Protection against pollution of potable water installations
and general requirements of devices to prevent pollution by
backflow)
• EN 378 (Refrigerating systems and heat pumps - Safety and
environmental requirements)
3