Advertisement
Quick Links
Advertisement
Related Manuals for FRENCH FITNESS T300
Summary of Contents for FRENCH FITNESS T300
- Page 1 FF-T300 FRENCH FITNESS T300 LIGHT COMMERCIAL TREADMILL ASSEMBLY MANUAL...
- Page 2 ...
- Page 17 Parameter Specification Motion Parameters under different running modes: · Lowest speed displayed: 1 km/h · Highest speed displayed: 25 km/h · Longest running time under TIME MODE: 99 mins · Shortest running time under TIME MODE: 8 mins · Longest running distance under DISTANCE MODE: 99 km ·...
- Page 18 2. When automatic program is set, display the serial number of the program CALORIE window: 1. Display calories consumed when running HEART RATE window: 1. Display the corresponding heart rate when both hands grasp the heartbeat sheet steel INCLINE window: 1. Display the running incline when running 2.
- Page 19 After under automatic program setting, fat rate test setting may be available if continue to use this key. 3. Operation process: automatic program setting —fat rate test setting — Full-manual operation mode · MODE— functional description: selects countdown mode Operation instruction: 1. This key may access to setting of countdown mode when electronic meter is under full-manual operation mode 2.
- Page 20 Operation instruction: Initial speed is 1KM/H. Positive counting of time, distance, and calorie is started from 0. Adjust running speed through SPEED +/- and incline through INCLINE +/-. If the running time exceeds 99 h and 59 min, system will not stop and the time will recount from 0.
- Page 21 When the set calorie counts down to 0, the electronic meter gradually stops. Once the speed reduces to 0, speed window immediately displays “End” in company with 5 prompt tones (each per second). Five seconds later, all data are reset and the electronic meter automatically goes back to initial standby state.
- Page 22 VIII. Sleeping Function Specification on Safety Key Function Specification on Quick Stop After safety key is connected, the quick stop switch must be closed for the normal start of the treadmill. When the treadmill is running, once pressing STOP, it will quickly stop. The lattice window of the electronic meter displays “QUICK STOP OPEN”.
- Page 23 6: Electronic meter display: E0B! Raise and fall failure Troubleshooting: check to see if the connection wire of incline motor is properly connected to the frequency converter; replace motor 7: Electronic meter display: E0C! Overheat protection 8: Electronic meter display: Safety key disconnected Troubleshooting: check if magnetic safety key is properly placed;...
- Page 25 1-20.8KM/H 0-18%...
Need help?
Do you have a question about the T300 and is the answer not in the manual?
Questions and answers