Exchange Of Battery - TC Electronic ATAC Service Manual

Exchange of battery:

DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED.
REPLACE ONLY WITH SAME OR EQUIVALENT TYPE RECOMMEND BY
THE MANUFACTURER. DISCARD USED BATTERIES ACCORDING TO THE
MANUFACTURERS INSTRUCTIONS.
Felaktigt batteribyte kan medfora fara for explosion. Anvand darfor endast samma typ
eller likvardig typ enligt apparattillverkarens rekommendation.
Kassera forbrukade batterier enligt tillverkarens anvisning
Lithiumbatteri. Eksplosionsfare ved fejlagtig håndtering. Må kun udskiftes med batteri
af samme fabrikat og type.
Lever det brugte batteri tilbage til leverandøren.
Recommended battery type: CR2032.
TC stock no. (TCcode) for battery: 342 0000 11
______________________________________________________________________________________________________________________________________________________________________________
________________
TC Electronic A/S
CAUTION:
VARNING:
ADVARSEL:
Exchange procedure:
1. Turn Off Power and Disconnect Power Cord.
2. Place the ATAC with the front panel facing down. In this way the buttons will stay
in the front panel when the cover is removed, see fig. 1.
3. Loosen four screws at the bottom. and remove the cover
4. Desolder the old battery by warming up each terminal one by one. Avoid any
short circuit of the terminals. Be careful not to damage the wiring on the board.
5. Insert new battery and solder the terminals one by one. Avoid any short circuit of the
terminals.
6. The voltage measured directly across the terminals of the new battery should be
higher than 3.0VDC.
7. Do not discard the old battery. Hand it over to a recycling company or your dealer.
ATAC Service manual page 8