Haussmann 59595073 Operator's Manual page 22

OPERATION
1) Set the rotational direction switch to the centre position in order to avoid
unintentional starting.
2) Insert the charged battery into the handle as shown in Pic.B so that it can
be felt to engage and faces flush against the handle.
Switching on:
To start the tool, squeeze on the On/Off switch and then keep it pressed down.
Note:
The LED work light lights up when the On/Off switch is slightly depressed, and
enables illumination of the screwing location in unfavorable light conditions.
Switching off:
To stop the tool, release the On/Off switch.
Reversing the Rotational Direction
The rotational direction switch is used to reverse the rotational direction of the
machine. However, this is not possible with the On/Off switch actuated.
Setting the Torque
The required torque can be preselected in 11 positions with the torque
preselection ring. With the correct setting, the insert bit is stopped as soon as the
screw is screwed flush into the material or when the set torque is reached.
Select a higher setting when driving out screws, or set to the symbol "Drilling".
The safety clutch is deactivated in the "Drilling" position.
Adjusting the Speed
The speed of the switched on power tool can be variably adjusted, depending on
how far the On/Off switch is pressed.
Light pressure on the On/Off switch results in a low rotational speed. Further
pressure on the switch results in an increase in speed.
Fully automatic spindle locking (Auto-lock)
When the On/Off switch is not pressed, the drill spindle and thus the tool holder
are locked.
This enables screws to be screwed in, even when the battery is empty and allows
for the machine to be used as a screwdriver.
Run-on Brake
When the On/Off switch is released, the chuck brakes to a stop, thus preventing
the run-on of the tool.
When driving in screw, wait until the screw is screwed in flush with the material
and then release the On/Off switch. By doing so, the head of the screw does not
penetrate into the material.
22