Table of Contents
Advertisement
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book carefully.
Intended Use
The machine is intended for cutting, roughing and brushing metal and stone materials without using water. For cutting
metal, a special protection guard for cutting (accessory) must be used.
BEFORE PUTTING INTO OPERATION
A) CHARGING THE BATTERY
The battery supplied is partially charged. To ensure full capacity of the battery, completely charge the battery in the
battery charger before using your power tool for the first time.
The battery charger supplied is matched to the Li-ion battery installed in the machine. Do not use another battery charger.
The Li-ion battery is protected against deep discharging. When the battery is empty, the machine is switched off by
means of a protective circuit: The chuck no longer rotates.
NOTE: If the battery pack is very hot you must remove your battery pack from the charger and allow your battery pack to
cool first to ambient temperature and then recharging can be started.
The battery must be fully charged before storage. If the tool is not used for long periods, recharge the battery at least
every 3-6 months.
B) TO REMOVE THE BATTERY PACK (See Fig. A1)
Depress the Battery Pack Release Button (5) firmly first
and then slide the Battery Pack (4) out from your tool.
C) TO INSTALL THE BATTERY PACK (See Fig. A2)
Slide the fully charged Battery Pack (4) onto the tool with
sufficient force until it clicks into position.
Fig. A1
Fig. A2
13
Advertisement
Table of Contents
