Table of Contents
Advertisement
3. INSTALLING AND ADJUSTING THE DISC GUARD
(See Fig. C1, C2, C3)
For work with grinding or cutting discs, the disc guard
must be mounted.
Disc Guard for Grinding (7)
The coded projection on the disc guard (7) ensures that
only a guard that fits the machine type can be mounted.
Loosen the clamp adjustment nut (12), if necessary. Place
the disc guard with coded projection into the coded
groove on the spindle of the machine head and rotate to
the required position (working position).
Tighten the disc guard (7). The closed side of the disc
guard must always point to the operator.
Disc Guard for Cutting (not supplied)
WARNING! For cutting metal, always work with
the disc guard for cutting. The disc guard for
cutting is mounted in the same manner as the disc guard
for grinding.
4. FITTING THE DISCS (See Fig. D1, D2, D3)
Put the inner flange (10) onto the tool spindle. Ensure it is
located on the two flats of spindle (See Fig. D1).
Place the disc on the tool spindle and inner flange (10).
Ensure it is correctly located. Fit the threaded outer
flange (11) making sure it is facing in the correct direction
for the type of disc fitted. For grinding discs, the flange is
fitted with the raised portion facing towards the disc. For
cutting discs, the flange is fitted with the raised portion
facing away from the disc (See Fig. D2).
Fig. C1
Fig. C2
Fig. C3
Fig. D1
a
Fig. D2
15
10
Grinding disc
(not supplied)
b
11
10
Cutting disc
(not supplied)
11
Advertisement
Table of Contents
