Table of Contents
Advertisement
Press in the spindle lock button (2) and rotate the spindle
by hand until it is locked. Keeping the lock button
pressed in, tighten the outer flange (11) with the spanner
(9) provided. (See Fig. D3)
NOTE: After mounting the grinder tool and before switch
on, check that the grinding tool is correctly mounted and
that it can be turn freely, make sure that the grinding tool
does not graze against the protecting guard or other
parts.
5. SPINDLE LOCK BUTTON
Must only be used when changing a disc. Never press when the disc is rotating!
6. ON/OFF SWITCH (See Fig. E)
To start the power tool, first press the back of on/off
switch (6), then push the on/off switch (6) forward.
To lock the on/off switch (6), press the on/off switch (6)
down at the front until it engages.
To switch off the power tool, briefly press down the back
of the on/off switch (6) and then release it.
7. TO USE THE GRINDER (See Fig. F)
ATTENTION: Do not switch the grinder on whilst
the disc is in contact with the workpiece. Allow
the disc to reach full speed before starting to grind.
Hold your angle grinder with one hand on the main handle
and other hand firmly around the auxiliary handle (1).
Always position the guard (7) so that as much of the exposed
disc as possible is pointing away from you.
Be prepared for a stream of sparks when the disc touches
the metal.
For best tool control, material removal and minimum
overloading, maintain an angle between the disc and work
surface of approximately 15
Use caution when working into corners as contact with the
intersecting surface may cause the grinder to jump or twist.
When grinding is complete allow the workpiece to cool. Do
not touch the hot surface.
-30
when grinding.
0
0
Fig. D3
Fig. F
16
2
1
Fig. E
15
-30
o
o
Advertisement
Table of Contents
