Operating Instructions - Wickes PGA2301 Quick Start Manual

OPERATING INSTRUCTIONS

NOTE: Before using the tool, read the instruction book carefully.
Intended Use
The machine is intended for cutting, roughing and brushing metal and stone materials without using water. For cutting
metal, a special protection guard for cutting (accessory) must be used.
This tool may cause hand-arm vibration syndrome if its use is not adequately managed
1. INSTALLING THE AUXILIARY HANDLE (See Fig. A)
For all work with the machine, the auxiliary handle (1)
must be attached.
Screw the auxiliary handle (1) on the right or left or top of
the machine head depending on the working method.
WARNING! Do not make any alterations to the
auxiliary handle.
Do not continue to use an auxiliary handle if it is
damaged.
2. SPINDLE LOCK BUTTON
Clean the grinder spindle and all parts to be mounted. For clamping and loosening the grinding tools, lock the grinder spindle
with the spindle lock button (2).
Press the spindle lock button (2) only when the grinder spindle is at a standstill!
3. ADJUSTING DISC GUARD (See Fig. B)
For work with grinding or cutting discs, the disc
guard must be mounted.
Disc Guard for Grinding (7)
The coded projection on the disc guard ensures that
only a guard that fits the machine type can be mounted.
Open the clamping lever. Place the disc guard with
coded projection into the coded groove on the spindle
of the machine head and rotate to the required position
(working position).
To fasten the disc guard, close the clamping lever.
The closed side of the disc guard must always point to
the operator.
Fig. A
Fig. B1
10
1
2