6-4. Controls, MIG Mode (Menu 1 Of 5)
2
OM-285922 Page 32
4
5
1
Process Select Button
Push button to enter MIG process.
Check weld parameter chart for
correct polarity at positive (+) and
negative (−) receptacles.
See section 5-11 for proper cable
placement.
2
Voltage Knob
Adjust voltage knob per weld pa-
rameter chart for initial setting.
3
Wire Feed Knob
Adjust wire feed knob per weld pa-
rameter chart for initial setting.
4
Display
5
Live Output Signal
.
When the symbol is activated
on the display the output is on.
3
The output is on in the MIG process
when the trigger on the MIG gun or
spoolgun is activated.
1
Ref. 287758-A
Need help?
Do you have a question about the Multi-Handler 200 and is the answer not in the manual?