4 Maintenance
10.Mount the strainer and the nuts.
Tightening torque: 22 Nm (16.2 ft-lb)
4.6.11 Install the impeller: Sludge version
1. Prepare the shaft:
a) Polish off any flaws with a fine emery cloth.
b) Coat the inner conic, the outer cylindrical surfaces, and the thread of the conical
52
The end of the shaft must be clean and free from burrs.
sleeve with a thin layer of grease.
The proper lubrication is grease for bearings, for example Exxon Mobil Unirex N3,
Mobil Mobilith SHC 220 or equivalent.
2640.181/.281 Service and Repair Instructions