Zanussi ZTE170 Instruction Booklet page 13

125987771 EN_1.qxp 2007-07-13
the machine is per-
forming the count-
down, after having
done so and having
closed the door, press
START/PAUSE
again, in order to
allow the machine to
complete the remain-
ing countdown time.
Indicator lights
These lights indicate
the following func-
tions:
• Drying light
This light indicates
that the appliance
is in the drying
phase.
• End of pro-
gramme light
This light is on at
the end of the
cooling phase,
during the anti-
creasing phase
and at the end of
the programme.
• Water reservoir
full light
This light indicates
that the appliance
is in the drying
phase.
This light comes
on at the end of
the programme to
remind you that
the water reser-
voir must be emp-
tied out. If this
09:38 Page 13
light illuminates If the laundry is not
during a pro- removed at the end of
gramme this the cycle, the dryer
means that the performs an anti-
water reservoir is creasing phase (dura-
full. The buzzer tion: 30 minutes maxi-
sounds, the pro- mum).
gramme stops,
If you do not remove
the light of the
the laundry, the dryer
Start/Pause
will stop automatically
button flashes.
at the end of the anti-
This light comes
creasing phase.
on also when the
Lights End/Anticrease
water reservoir is
not inserted cor-
and the buzzer
rectly.
sounds for 2 minutes.
• Filter cleaning
Turn the programme
This light illumi- selector dial to "O" to
nates at the end switch the machine
of the programme off. Remove the laun-
to remind you that dry from the drum and
the filters must be carefully check that
cleaned. the drum is empty.
• Condenser If you do not intend to
cleaning carry out another
wash, close the water
It comes on every
tap. Leave the door
80 cycles to
open to prevent the
remind you that
formation of mildew
the condenser
and unpleasant
must be cleaned.
smells.
Turn the programme
Cancelling a
selector dial to "O"; all
programme
the lights go out. The
appliance is switched
Turn the selector dial
off.
to "O" to cancel a pro-
gramme which is run-
Remove the laundry.
ning. Now you can
If you open and then
select a new pro-
close the door before
gramme.
turning the selector
dial to "O" all the
lights corresponding
At the end of the
to the phases making
programme
up the performed pro-
gramme come on.
After each use
• Clean the filters.
• Empty the water
reservoir.
Important!
If the drying pro-
gramme has to be
, and remain lit
stopped before it
reaches the end, we
recommend that you
turn the programme
selector dial to posi-
tion Cooling
wait until the end of
this cooling phase
before removing the
laundry. This will
avoid a build-up of
heat inside the appli-
ance.To do this first
turn the dial to "O"
and then to Cooling
and depress Start but-
ton.
Modifying
the programme
To change a pro-
gramme which is run-
ning, first cancel it by
turning the pro-
gramme selector dial
to "O". Select the new
programme and press
the Start button.
and
13