Startup / Operation - BOMANN SBS 7324.1 IX Instruction Manual

Household side by side fridge / freezer
Table of Contents

Advertisement

Available languages

Available languages

near volatile or flammable materials (e.g. gas,
-
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
Do not expose the appliance any weather.
-
Levelling the appliances doors
If the doors are not at the same level and do not
close parallel to each other, the refrigerator door
must be aligned.
Maximum tolerance compensation is 5 mm!
Open the door, loosen the locknut (2) with a wrench
(3)..
if the refrigerator door is too low
..
nut (1) counterclockwise to raise the door.
if the refrigerator door is too high
..
nut (1) clockwise to lower the door.
Once the doors are aligned, retighten the locknut (2).
Electrical connection
WARNING:
 The installation to the mains supply must conform
to the local standards and regulations.
 Improper connection may cause to an electric
shock!
 Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
 The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
 Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
, turn the adjusting
, turn the adjusting
20
 Connect the mains cable to a properly installed
and earthed wall outlet.
 If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.

Startup / Operation

Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for four hours before connecting to the power
supply. Nonobservance could lead to malfunction of
the cooling system and causes an appliance break-
down.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter "Cleaning and Maintenance".
Control panel
GENERAL NOTE:
 About 10 seconds after the last button press, the
control lamps stop flashing and the settings are
activated.
 About 60 seconds after the last button press, the
display will enter the standby mode.
The standby mode is terminated as soon as but-
tons are pressed, or device door is opened.

Advertisement

Table of Contents
loading

Table of Contents