WORMS ACCESS 3000i Instructions For Use Manual page 45

11.4. MUFFLER SCREEN AND SPARK ARRESTER
The engine and muffler will be very hot after the engine has been run. Avoid
touching the engine and muffler while they are still hot with any part of your
body or clothing during inspection or repair.
1. Remove the screws, pull outward on the areas of the cover shown (FIG. 28);
2. Loosen the bolt and the remove the muffler cap, the muffler screen and spark arrester (FIG.
29-30);
3. Clean the carbon deposits on the muffler screen and spark arrester using a wire brush. (FIG.
31);
NOTE
When cleaning, use the wire brush lightly to avoid damaging or scatching of muffler screen and spark
arrester.
4. Check the muffler screen and spark arrester. Replace them if damaged;
5. Install the spark arrester. Align the spark arrester projection with the hole in the muffler pipe;
6. Install the muffler screen and the muffler cap;
7. Install the cover and tighten the screws.
11.5. FUEL TANK FILLER
Never use the gasoline while smoking or in the vicinity of an open flame
1. Remove the fuel tank cap and filter. (FIG. 32)
2. Clean the filter with gasoline.
3. Wipe the filter and install it.
4. Install the fuel tank cap.
Be sure the fuel tank cap is tightened securely.
EN
FR
ES
IT
RO
45