Stopping The Generator; Low Oil Security - WORMS ACCESS 3000i Instructions For Use Manual

Do not put foreign objects into the plug receptacle.
NOTE
The economy control switch have to be turn "OFF" in order to have an higher engine speed during
nominal use. If the generator set is connected to multiple loads or electric appliances, please first
connect to one with the highest starting power, then, the one with the second highest starting power,
and connect others one by one, each with a lower starting power than the preceding one, finally,
connect the one with the lowest starting power.
This generator is equipped with a circuit breaker which acts as security of overload. If the electric
current distribution is interrupted during using, this can be due to one overload which causes the circuit
breaker release or of the devices which is defective. When the circuit breaker or no-fuse breaker turns
off during operation, the generator is overloaded or the appliance is defective. In that case, wait for a
few moments, remove the overload cause, then turn off generator and start it again.

7. STOPPING THE GENERATOR

1. Turn off the economy control switch by pushing on "OFF" (FIG. 09)
2. Turn off the power switch of the electric equipment and unplug the cord from receptacle of the
generator
3. Allow engine about 3 minutes to cool down at no-load before stopping
4. Turn the 3 positions switch knob to the position "OFF". (FIG. 02)
NOTE
To stop the engine in an emergency, turn the generator switch to the OFF position. (FIG. 02)

8. LOW OIL SECURITY

•
The oil sensor detects the fall in oil level in the crankcase and automatically stops the engine when the oil
level falls below a predetermined level.
•
When engine has stopped automatically, switch off generator's no-fuse breaker, and check the oil level.
Refill engine oil to the upper level as instructed on page 37 and restarts the engine.
NOTE
If the engine doesn't start by usual, consult your nearest Worms Entreprises dealer or service shop.
EN
FR
ES
IT
RO
39