Maintenance Instructions - Master X-17 Owner's Manual

Spin-bike

Hide thumbs Also See for X-17:

Table of Contents

Available languages

STEP 5.

Loosen off the two bolts(45) on the frame. Position the bottle holder (46) on frame(1) then tighten up the bolts.

MAINTENANCE INSTRUCTIONS

Care has been taken to assure that your bike has been properly adjusted and lubricated at the factory. It is not re

commended that the user attempt service on the internal components instead seek service from an authorized se

rvice center. However, from time-to-time the outer surfaces may appear dull or dirty, following the instructions

listed below will restore and preserve the original finish.

 Cleaning metal surfaces may be accomplished by using a soft cotton or terry cloth rag with a light applic

ation of car wax. Do not use aerosol sprays or pump bottles as they may deposit wax upon the console s

urface.

 From time-to-time the console surface may collect dust or finger prints. The use of harsh chemicals will

destroy the protective coating and cause a static build up that will damage the components. This surface

may be cleaned with specially prepared chemicals found in most computer supply stores especially mad

e for antistatic surfaces. It is strongly recommended that you purchase such a cleaning compound.

 The safely level of the equipment can only be maintained if it is regularly examined for damage and/or

wear and tear.

 Care must be taken when lifting or moving the equipment so as not to cause injury.

 The brake pad is most susceptible to wear. Before exercising inspect braking system for functionality.

 Please check if all warning labels are in good condition and able to read. If they are deformed please con

tact the distributer to order new sticker.

RESISTANCE ADJUSTMENT:

Pedalling resistance is controlled by the tension knob (59) locate under the handlebar. To increase resistance. T

urn the tension knob (59) clockwise. To decrease resistance, turn the tension knob counter clockwise.

HOW TO LEVEL THE BIKE:

There are 4 levelle- knobs (10) under the stabilizers. Adjust the knob when the bike is not level with the floor.

Table of Contents