Table of Contents
Advertisement
7. Getting started
7.1 Remote control
• Open the battery compartment cover located on the rear of the remote control.
• Insert the batteries provided, making sure you match the polarities correctly. The correct polarity is
indicated by the plus and minus symbols in the battery compartment.
7.2 connecting and operating the radio
Warning
• Only operate the product from an approved socket that is connected to the public power supply. The
socket must be installed close to the product and must be easily accessible.
• Disconnect the product from the power supply using the On/Off switch – if this is not available,
unplug the power cord from the socket.
• If using a multi-socket power strip, make sure that the total power consumption of all connected
devices does not exceed the power strip's maximum throughput rating.
• If you will not be using the product for a prolonged period, disconnect it from mains power.
• Connect the network cable to a properly installed and easily accessible network socket.
• The power supply unit is suitable for mains voltages between 100 and 240 V, and is thus operable on
almost any AC power grid. Please note that a country-specific adapter may be necessary.
• You can find an appropriate selection of Hama products at www.hama.com.
1
Once the product has been connected to mains power, initialisation takes place.
The radio starts up.
AAA
AAA
2
14
GeTTING STARTeD
3
4
Advertisement
Table of Contents
