Location And Ventilation Requirements; Choosing The Right Location; Ventilation - Basic Principles; Grounding Instructions - Minibar Systems SmartFridge 65 User Manual

Minibar Systems
SmartFridge 65 Solid Door – Electronics on Door

2. Location and Ventilation Requirements

The SmartFridge User's Guide details the criteria necessary for the installation of the SmartFridge. These details are
essential for the efficient running of the SmartFridge's electronics and refrigeration systems ensuring its long life span
and trouble free operation.

2.1 Choosing the Right Location

Place the SmartFridge in a dry and regularly ventilated room. Do not place the SmartFridge near a heat source
and do not expose to direct sunlight.
2.2 Ventilation – Basic Principles
Ventilation occurs by convection. Convection is the movement of air caused by the tendency of hotter
and less dense air to rise, and colder, denser air to sink under the influence of gravity, which consequently
results in transfer of heat.
The exhaust vent must exit into free space in the room. It must not vent into an enclosed space such as a
closet, case good or ceiling void, as the heat will be trapped. The SmartFridge must not be placed against a
heating radiator, window, curtains, or in direct sunlight. Ventilation grills or slots must not be covered.

3. Grounding Instructions

The mains power outlet socket should be located within close proximity of the SmartFridge.
A standard AC mains outlet socket with safety ground is provided. The AC mains supply to the SmartFridge must be
clean and stable.
The power cord that is supplied with the SmartFridge has the appropriate grounding conductor and grounding
plug. The plug must be plugged into an appropriate wall outlet that has been installed and grounded in accordance
with all existing local codes and ordinances. The required nominal voltage and frequency are indicated on the rating
plate (inside the unit or on the exterior rear wall of the unit).
Consult a qualified electrician if in any doubt.

4. Installation

4.1 Before Putting in Use

BEFORE CONNECTING THE SMARTFRIDGE TO AN ELECTRICAL POWER SUPPLY LET IT
STAND FOR 24 HOURS. THIS WILL REDUCE THE POSSIBILITY OF MALFUNCTIONS IN THE
COOLING SYSTEM DUE TO TRANSPORT HANDLING.
Clean the SmartFridge thoroughly especially the interior (see "Maintenance and Cleaning"). In case the interior
shelves are not correctly placed, rearrange as shown in "Description of the SmartFridge".
DOC0118_SmartFridge 65 Solid Door - Electronics on Door_Rev-5.doc Page 4