Advertisement
Operation Instruction
Adjusting Rinse Aid Dispenser
Detergent
Detergents have chemical ingredients that are necessary to remove dirt, crush dirt and transport it out of
the dishwasher.
Most of the commercial quality detergents are suitable for this purpose.
Normally new pulverised detergent is without phosphate,thus the water softener function of
phosphate is not given. If detergents without phosphate were used in case of hard water
often white spots appear at dishes and glasses. In this case please add more detergent to reach
better results. Detergents without chlorine do only bleach a little. Strong and coloured spots will not
removed completely. In this case please choose a program with higher temperature.
Concentrated Detergent
Based on their chemical composition, detergents can be split in two basic types:
■
Conventional, alkaline detergents with caustic components.
■
Low alkaline concentrated detergents with natural enzymes.
The use of Normal washing program in combination with concentrated detergent reduces pollution and is
good for your dishes.
Detergent Tablets
Detergent tablets of different brands dissolve at different speeds. For this reason some detergent tablets
cannot dissolve and develop their full cleaning power during short program. Therefore please use long
program when using detergent tablets, to ensure the complete removal of detergent residuals.
Detergent Dispenser
The dispenser must be refilled before the start of each wash cycle following the instructions provided in the
Wash Cycle Table. Your dishwasher uses less detergent and rinse aid then conventional dishwasher.
Generally, only one tablespoon of detergent is needed for a normal wash load. More heavily soiled items
need more detergent. Always add the detergent just before starting the dishwasher, otherwise it could get
damp and will not dissolve properly.
The rinse aid dispenser has six or four settings. Always start with the
dispenser set on "4". If spots and poor drying are a problem, increase the
amount of rinse aid dispensed by removing the dispenser lid and rotating
the dial to "5". If the dishes still are not drying properly or are spotted,
adjust the dial to the next higher number until your dishes are spot-free.
The recommended setting is "4". (Factory value is "4".)
NOTE:
Increase the dose if there are drops of water or lime spots on the dishes
after washing. Reduce it if there are sticky whitish stains on your dishes
or a bluish film on glassware or knife blades.
11
Advertisement
