Nortel Contivity 4500 Getting Started page 76

Getting Started with the Contivity Extranet Switch 4500
Software
1.
2.
Hardware
Remove the Switch front bezel (refer to page 7-7), then follow these steps:
1.
NOTE:
2.
3.
4.
5.
Software
1.
2.
7-12
Launch a Web browser to the Switch, and go to the Admin → File
System display.
Click the button "Prepare selected device for removal."
This action saves any data that has not yet been saved to the hard disk
from the disk cache.
Insert and turn the hard disk drive key to the right. The LED becomes a
"U" for unlocked.
Turning the key shuts off the power to the hard disk drive.
Pull the handle to remove the hard disk drive.
Insert the replacement hard drive fully, and lock it by turning the
key to the left. Make sure the hard disk drive LED shows the
proper drive number.
Replace the front bezel.
Reload the software on the disk. Refer to the "Admin → Recovery"
section in the guide Managing the Contivity Extranet Switch.
Launch a Web browser to the Switch, and go to the Admin → File
System display.
Click on the drive and click the "Enable" button.