Nortel Contivity 4500 Getting Started page 72

Getting Started with the Contivity Extranet Switch 4500
Remove the front bezel to:
•
•
•
The first few times you remove the front bezel it might seem to resist removal.
This is simply because the pins and snaps are new. After a few times, removal is
easier. Remove the Switch front bezel as follows:
1.
2.
3.
7-8
Replace a power supply.
Replace a hard disk drive.
Insert the recovery diskette.
Insert a flat-head screwdriver into the slots on the lower left and right side
of the chassis, and pry the bezel forward.
Slide your fingers between the front bezel and the Switch.
Pull the bezel forward firmly.
D isk D riv es
Figure 7-5.
3 .5 " F lo p p y D riv e
P o w er S u p p lie s
4500 Front Components
0