BCN3D Epsilon Series User Manual page 36

Setup Assistant
i
Follow the instructions below or in our Knowledge Base.
Skip installing shims: Although this option will correct the offset, the printed part from one extruder may
•
experiment different adhesion.
Install shims to mechanically correct the Z offset: Printing a raft takes time and wastes material. For those users
•
planning to use the Mirror or Duplication modes frequently, it is highly recommended to install the shims when
it is suggested during the Printer Calibration process.
- Select Install.
- Wait until the printer cools down to avoid any dangerous manipulation.
- Turn off the printer with the power switch at the left side of the printer. Take note of the amount of shims
that have to be installed.
- Loose the 2 bolts at the specified hotend.
User Manual 36