BCN3D Epsilon Series User Manual page 33

Setup Assistant
The process starts calibrating the Z offset of the left extruder.
•
The hotend heats up. After that, it is mandatory to clean the nozzle with a piece of paper or metal brush, so that
•
no rests of filament is on the tip of the nozzle. This is important because during calibration, a gauge has to be
placed between the nozzle and the glass.
When indicated on the screen, apply a thin and uniform layer of printing adhesive (Magigoo glue stick included in
•
the Upper Box) on the entire printing surface glass to ensure a better calibration.
Place the Calibration Gauge (included in the accessory box inside the Upper Box) between the nozzle and the
•
printing surface glass, hold the other end and move it back and forth, without pressing the platform. Use the
arrows on the screen to raise (^) or lower ( ) the platform until you feel some resistance while sliding the gauge.
The gauge should not flex. Tap on the Accept button when it is done.
User Manual 33