Input Control - Philips HFL3014/12 Series Professional Installation Manual

6.12 Input Control

o Navigate to the [Input control] [Remote
Control] menu
o You will see below items:
o [Lock]: The TV will not respond to any
RC codes sent to TV by putting Lock to
[On], normally this should always be
[Off]
Note: Using the master RC you
would still be able to enter in
the professional menu and
navigate in it
o [Watch TV RC Key Mapping]: You can
map the "Watch TV" button on the RC
to different sources (Channels, HDMI
sources, SCART, VGA, USB Media
Browser)
o Navigate to the [Input control] [Multi
Remote Control] menu
o This function allows that up to 14
televisions can be installed in a room
whereas each TV will react to its own RC
o You will see a list of options ('Off', the 4
color keys and all digits)
o The TV will only react on the RC that is
programmed linked to your selection
Note: The TV will still respond to the
master RC
o Once the TV is set to some value other
than [Off], also the RC should be
programmed to the same selection to still
work with the TV
o How to program the RC:
o Press and hold both the menu and the
color button or digit button on the RC
for about five seconds (You should not
point the RC to the receiver on the TV)
o To see the status of the remote control,
while pointing at the TV, press and hold
the "Mute" button for about five
seconds until you get a notification on
screen
o You will see the battery status of the
RC, the setting programmed in the RC
(default = blue) and the setting in TV
Note: See also more details in chapter
'Remote control'
- 38 -