Quick Start Guide - Victron energy Blue Smart IP22 Charger 12/15 Manual

1. Quick Start guide

a) Connect DC cables to the charger and then the battery or batteries; ensure that there is a good
electrical connection and keep the terminals away from any surrounding objects that could
cause a short circuit.
b) Connect the AC power cable to a mains power outlet; the BULK LED will be illuminated when
the Blue Smart Charger is powered up.
c) Select the charge mode appropriate for the battery type; briefly press the MODE button to cycle
through the available options, the LED beside the currently selected charge mode will be
illuminated.
The charger will automatically store the selected charge mode and recall it for future charge
cycles (even after being disconnected from power).
When recondition mode is selected, the RECONDITION LED will be illuminated in addition to
the selected charge mode LED.
If required, activate night mode (disabled fan and reduced charge current for 8h); depress and
hold the MODE button for 3 seconds, when activated the NIGHT LED will be illuminated. Night
mode will automatically end after 8 hours or depress and hold the MODE button for 3 seconds
again to end night mode earlier.
3