In the event that the power founda on fails to operate, assess the symptoms and possible solu ons
SYMPTOMS
Head & Foot li func on has minor
interference during opera on.
Excessive massage motor noise.
provided in the chart below.
SOLUTIONS
Check ba eries in wireless remote control, replace with two (2) new AAA ba eries if
necessary.
Make sure that you are following the duty cycle of the motors (do not operate more than
two minutes over a 18-minute period, or approximately 10% duty cycle).
Press the li bu ons squarely and accurately.
Wireless remote control may be experiencing common Radio Frequency Interference
from other radio transmi ng devices. Wait several seconds, and then try pressing
appropriate bu on again, See FCC Compliance Statement on page 5 of this guide.
If the bed is located on hard surface ooring, place carpet pieces or rubber pieces (not
included) under each leg.
Using the wireless remote control, elevate the head, foot or neck sec on a short distance
to realign the li /lower mechanisms with the bed support pla orm.
Verify that your Power Founda on is not posi oned against a wall, nightstand, or other
object that may cause the vibra on or noise.
If the Power Founda on is installed over a bed frame, verify that the massage motors are
not causing the bed frame (or bed frame components) to vibrate.
Verify that the headboard a achment hardware is properly ghtened (if used).
22-23
Need help?
Do you have a question about the FE3500 Wireless Adjustable Base and is the answer not in the manual?