Symbols On The Product; Symbols In Automower ® Connect - Husqvarna AUTOMOWER 520 Operator's Manual

24. Screws for securing the charging station
25. Operator's manual and Quick Guide
26. Couplers for loop wire
27. Loop wire for boundary loop and guide wire
3
4
28. Stakes
29. Connector for the loop wire

1.4 Symbols on the product

These symbols can be found on the product.
Study them carefully.
WARNING: Read the
user instructions before
operating the product.
WARNING: Disable the
product before working on
or lifting the product.
WARNING: Keep a safe
distance from the product
when operating. Keep
your hands and feet away
from the rotating blades.
WARNING: Do not ride
on the product. Never put
your hands or feet close
to or under the product.
Never use a high-pres-
sure washer or even run-
ning water to clean the
product.
Use a detachable power
supply as defined on the
rating label next to the
symbol.
This product conforms to the
applicable EC Directives.
Noise emission to surroundings. The
product's emissions are set out in
2
Is a part of the Installation kit which is purchased separately.
3
See note 2
4
See note 2
5
See note 2
1439 - 002 -
2
5
Technical data on page 55 and on the
rating plate.
It is not permitted to dispose this
product as normal household waste.
Ensure that the product is recycled in
accordance with local legal
requirements.
The chassis contains components
which are sensitive to electrostatic
discharge (ESD). The chassis must
also be resealed in a professional
manner. For these reasons the chassis
shall only be opened by authorized
service technicians. A broken seal can
result in the entire or parts of the
warranty no longer being valid.
The low voltage cable must not be
shortened, extended or spliced.
Do not use a trimmer nearby the low
voltage cable. Be careful when
trimming edges where the cables are
placed.
1.5 Symbols in Automower
The schedule menu is used to set
when the product cuts the lawn.
The cutting height menu allows the
operator to set the cutting height of the
product.
The operation menu is used for
manual settings for the operation.
The installation menu is used for
manual settings for the installation.
®
Connect
Introduction - 5