Table of Contents
Advertisement
®
R&S
SMW-K548
Return values:
<ArbCfrOCrestFac> float
Example:
Usage:
Manual operation:
[:SOURce<hw>]:BB:ARBitrary:CFR:PFReq <ArbCfrPassBFreq>
Sets the passband frequency, if
set to ENHanced. Frequency components lower than the passband frequency are
passed through unfiltered.
Parameters:
<ArbCfrPassBFreq> float
Example:
Manual operation:
[:SOURce<hw>]:BB:ARBitrary:CFR:RCFactor?
Queries the resulting crest factor of the waveform after the calculations are completed.
The resulting crest factor is calculated as an average over the whole waveform, includ-
ing any idle periods that might be present in TDD waveforms.
Return values:
<ArbCfrResCreFac> float
Example:
Usage:
Manual operation:
[:SOURce<hw>]:BB:ARBitrary:CFR:SBANdwidth <ArbCfrSignalBw>
Sets the signal bandwidth, if
to SIMPle.
The value of the signal bandwidth should not be higher than the channel spacing
SOURce<hw>]:BB:ARBitrary:CFR:CSPacing).
User Manual 1179.0939.02 ─ 01
Range:
1 to 100
Increment: 0.01
*RST:
6
See
Example "Configuring the CFR"
Query only
See
"Original Crest Factor"
[:SOURce<hw>]:BB:ARBitrary:CFR:FILTer
Range:
0 to depends on the sample rate of the loaded file
Increment: 0.1
*RST:
250E6
See
Example "Setting up an Enhanced Filter"
See
"Passband Freqeuncy"
Range:
1 to 100
Increment: 0.1
*RST:
6
See
Example "Configuring the CFR"
Query only
See
"Resulting Crest Factor"
[:SOURce<hw>]:BB:ARBitrary:CFR:FILTer
Remote-Control Commands
on page 16.
on page 12
on page 16.
on page 14
on page 16.
on page 12
is
is set
([:
19
Advertisement
Table of Contents
