BOMANN KSE 337 Manual page 19

CAUTION CAUTION: : : :
CAUTION CAUTION
In case of disconnection or power failure:
Wait for approx. 5 minutes before restarting.
-
Check the operation settings.
-
• Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reverse the door o Reverse the Reverse the Reverse the door o door o door opening pening pening pening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING: WARNING: WARNING: WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply. Always unplug
the appliance first.
NOTE: : : : NOTE NOTE NOTE
• When installing, ask another person to assist.
You possibly need:
•
driver as well as a thin-blade screwdriver.
• Dismount the upper limit plate incl. hinge pin by
loosening the screws. Open the door a little and
take it carefully off the lower door hinge. Place the
door on a padded surface to prevent it from
scratches.
• Tilt the appliance slightly backwards and block it
in this position. Loosen the lower hinge pin and
put it in the opposite bracket.
• Replace the appliance upright again. Insert the
appliance door on the lower hinge pin and fix the
door to the property position.
screw wrench, Phillips screw-
• Attach the upper limit plate after you have un-
screwed the hinge pin and used it on the other
side of the plate. Insert the hinge pin in the hole of
the appliance door and tight the plate.
• Check if the door is arranged vertical as well as
horizontal, so that a smooth opening and closing
of the door is ensured.
Reverse the freezer door opening Reverse the freezer door opening Reverse the freezer door opening Reverse the freezer door opening
• Open the freezer door a little. Using a small
screwdriver, press the spring of the lower bracket
slightly upwards and remove the holder together
with the freezer door.
• Position the blind cap (M) on the opposite side.
• Turn the freezer door about 180° and press the
lower bracket into the appropriated fixture of the
freezer compartment.
• Lift the freezer door slightly a little and attach it to
the upper bracket, simultaneously press the lower
bracket into the square hole. Small adjustments
up and down facilitate the attachment of the
freezer door.
Built- - - - in in in in Built Built Built
Figures in mm
For the appropriate venting an exhaust duct of
approx. 50 mm depth is to provide at the appliance
back.
19
Built-in openings
Height x Width x Depth
1218–1226 x
560–570 x 550 mm