Beverage-Air HR Series Installation And Operating Instructions Manual page 15

User Manual for HR Refrigerators
Electronic Controller Alarms
Alarm Trigger
Code
"Hi" Air temperature is higher than
"ALA->Hat• for "ALA->Htd"
"Lo" Air temperature is lower than
"LAt" for "Ltd''
"Con" Condenser temperature is too
high or too low
"dor" Door open for more than
"uHi" Line voltage is higher than "Cop-
>uHi"
"uLi" Line voltage is higher than "Cop-
>uLi"
"LEA" Compressor cont inuous running
for more than "ALA->LEA"
"E01" "S1" error
"E02" "S1" error
"E03" "S1" error
"E04" "S1" error
The alarm condition is always signaled by the alarm icon
NOTE: If alarm exclusion times are in progress (ALA folder of the parameter table), the alarm is not signaled.
How to Acknowledge Alarms
Rev. 05/20
Automatic Outputs
Clearance
User Bl ink "Hi" with the highest temperature; If
configured configured: cut in alarm relay, beep the buzzer
User Blink "Lo" with the lowest temperatu re. If
configured configured: cut in alarm relay, beep the buzzer
User Blink "Con". If configured: cut in alarm relay, beep the
configured buzzer
Always Blink "dor". If configured: cut in alarm relay, beep the
buzzer
Always Blink "uHi". If configu red: cut in alarm relay, beep the
buzzer
Always Blink "ulo". If configured: cut in alarm relay, beep the
buzzer.
Always Blink "LEA". If configured: cut in alarm relay, beep the
buzzer
Always Blink "SOl ". lf configured: cut in alarm relay, beep the
buzzer
Always Blink "SO2". lf configured: cut in alarm relay, beep the
buzzer
Always Blink "S03 ". lf configured: cut in alarm relay, beep
the buzzer
Always Blink "SO4 ". lf configured: cut in alarm relay, beep
the buzzer
. To turn off the relative icon will continue flashing.
Beverage-Air
Beverage-Air
Comments
High temperature
alarm
Low temperature
alarm
Condenser alarm
Door open alarm
High voltage alarm
Low voltage alarm
Leakage alarm
"S1" sensor failure
(short or open)
"S2" sensor failure
(short or open)
"S3" sensor failure
(short or open)
"S4" sensor failure
(short or open)
15