Clock Functions - Zanussi ZOCND7K1 User Manual

Released humidity can cause burns. After the
function stops, carefully open the door.
1. Fill the cavity embossment with tap water.
The maximum capacity of the cavity
embossment is 250 ml.
Fill the cavity embossment with water only
when the oven is cold.
CAUTION! Do not refill the cavity
embossment during cooking or
when the oven is hot.
2. Set the function:
3. Turn the control knob to set temperature.
4. Preheat the empty oven for 10 minutes to
create humidity.
5. Put food in the oven.
Refer to "Hints and tips" chapter.
Do not open the oven door during cooking.
6. Turn the knob for the heating functions to the
off position to turn off the oven.

CLOCK FUNCTIONS

CLOCK FUNCTIONS TABLE
Clock function
Time of Day
Duration
End Time
Time Delay
Minute Minder
10
.
To show or change the time of day. You can change the time
of day only when the oven is off.
To set the length of cooking. Use only when a heating function
is set.
To set the oven turn-off time. Use only when a heating function
is set.
Combination of functions: Duration, End Time.
To set a countdown time. This function has no effect on the
operation of the oven.
Minute Minder - can be set at any time, also if the oven is off.
7. Remove water from the cavity embossment.
WARNING! Make sure that the
oven is cold before you remove
the remaining water from the
cavity embossment.
FAST HEAT UP
The fast heat up decreases the heat up time.
Do not put food in the oven when the
Fast heat up operates.
1. Turn the knob for the oven functions to set the
fast heat up.
2. Turn the knob for the temperature to set the
temperature.
The signal sounds when the oven is at the set
temperature.
3. Set an oven function.
HEAT-UP INDICATOR
When the oven function operates, the bars in the
display appear one by one when the
temperature in the oven increases, and disappear
when it decreases.
Application