Table of Contents
Advertisement
Programming
2
MbN: Select the desired setting. a MOKN
a M
N
Call restriction
You can restrict selected handsets from
dialling certain numbers. You can assign up to
6 phone numbers to be restricted, and select
which handsets are to be restricted. Storing
area codes here prevents the handset from
dialling any phone number in that area code.
1
M
N#256
2
Enter the base unit PIN (default: "0000").
R If you forget your PIN, contact an
authorised service centre.
3
MbN: Select the handsets to be restricted.
a M N
R To cancel the selected handset, press
M N again. " " disappears.
4
MOKN
5
MbN: Select a memory location. a MOKN
6
Enter the phone number or area code to
be restricted (8 digits max.). a MOKN a
M
N
Enhancing security for phone
calls
You can increase the security of phone
conversations by setting this feature to
"Enhanced". When "Enhanced" is selected,
is displayed. The default setting is
"Normal".
1
M
N#729
2
MbN: Selected the desired setting. a MOKN
3
M
N
Note:
R If you set repeater mode to "On"
(page 29):
– Security is set to "Normal" and
displayed.
– "Security" is not displayed in the
display menu (page 22).
R When enhanced security is enabled, sound
may cut in and out during conversations.
28
TGD51xHK(en-en)_0731_ver013.pdf 28
Changing the base unit PIN
Important:
R If you change the PIN (Personal
Identification Number), please make note of
your new PIN. The unit will not reveal the
PIN to you. If you forget your PIN, contact
an authorised service centre.
1
M
N#132
2
Enter the current 4-digit base unit PIN
(default: "0000").
3
Enter the new 4-digit base unit PIN. a
MOKN
4
MbN: "Yes" a MOKN a M
Registering a unit
Operating additional units
Additional base units
Handsets can be registered to up to 4 base
units, allowing you to add additional base units
and extend the area in which your handset(s)
can be used. If the handset moves out of
range of its base unit when "Auto" is selected
on base unit (page 29), it looks for another
base unit to make or receive calls. A base unit
and the handsets it communicates with is
called a "radio cell".
Note:
R Calls are disconnected when the handset
moves from one radio cell to another.
Registering a handset to a base unit
If for some reason the handset is not
registered to the base unit, re-register the
handset.
1
Handset:
M
N#130
is
2
MbN: Select a base unit number. a MOKN
R This number is used by the handset as
a reference only.
3
Base unit:
Press and hold M
N
N for about 5 seconds.
2019/07/31 17:21:42
Advertisement
Table of Contents
