Table of Contents
Advertisement
Before using for the first time
Displaying and setting the water
hardness
Open the door.
Switch the dishwasher off with the
button, if it is switched on.
Press the button in and, whilst
holding it in, switch the dishwasher
on using the button.
Keep the button pressed in for at
least 4 seconds until the indicator
light comes on.
If this does not happen, start the pro-
cedure from the beginning again.
Press the programme selection
button 2 times.
The top left indicator light will flash rap-
idly 2 times at intervals.
20
The value set for the water hardness is
shown as a figure after in the time dis-
play.
4 will start flashing in the time dis-
play.
A water hardness of 14 °dH is set.
Use the button to set the water
hardness value in your area.
The dosage amount increases each
time you press the button. When the
highest value is reached, the setting
starts again from the beginning.
The setting is now saved.
Switch the dishwasher off with the
button.
Hide quick links:
Advertisement
Table of Contents
