Advertisement
Quick Links
The Miele Waterproof system
Provided that your dishwasher has
been installed correctly, the Miele
Waterproof system will protect you from
water damage throughout its lifetime.
Water inlet
Health risk due to wash water.
Water in the dishwasher is not
drinking water.
Do not drink any water from the
dishwasher.
Health risk and risk of damage
due to contaminated incoming water.
The quality of the incoming water
must correspond to the drinking
water specification of the country in
which the dishwasher is being
operated.
Connect the dishwasher to a drinking
water supply.
11715550-03
The dishwasher may be connected to
cold or hot water (up to max. 60 °C)
supplies.
If energy-saving water heating sources
such as solar energy circulation
systems are used, we recommend
connecting to the hot water supply. This
saves both time and electrical energy
costs. Hot water is used in all
programmes.
The water inlet hose is approx. 1.5 m
long. A 1.5 m long, flexible metal
extension hose (tested to
14,000 kPa/140 bar) is available as an
optional accessory from Miele specialist
dealers or the Miele Customer Service
Department.
A stopcock with a ¾" threaded union is
required for the connection. If a
stopcock is not available, only a
qualified installer may connect the
dishwasher to the mains water supply.
The water connection pressure must be
between 50 and 1000 kPa. If the water
connection pressure is too high, a
pressure reducing valve must be fitted.
Installation
Advertisement
Related Manuals for Miele G 5050 C SCVi Active
Summary of Contents for Miele G 5050 C SCVi Active
- Page 1 14,000 kPa/140 bar) is available as an optional accessory from Miele specialist Health risk and risk of damage dealers or the Miele Customer Service due to contaminated incoming water. Department. The quality of the incoming water A stopcock with a ¾" threaded union is must correspond to the drinking required for the connection.
-
Page 2: Installation
*INSTALLATION* 11715550-03 Installation Risk of damage from leaking Risk of damage due to excessive water. pressure. The connection point is subject to A brief increase in the water pressure mains water pressure. Water leaking can damage components of the from it can cause damage. - Page 3 *INSTALLATION* 11715550-03 Installation Water drainage Lay the drain hose so that it does not kink and is not being subjected to The dishwasher’s drainage system is pressure or tension. fitted with a non-return valve, which prevents dirty water from flowing back ...
- Page 4 *INSTALLATION* 11715550-03 Installation Venting the water drain If the on-site drainage connection is situated lower than the guide path for the lower basket rollers in the open door, the drainage system must be vented. Otherwise, a siphoning effect during a programme can cause the appliance to empty itself of water.
- Page 5 If the mains connection cable is damaged, it must only be replaced with a specific mains connection cable of the same type (available from the Miele Customer Service Department). For safety reasons, such replacement may only be carried out by a qualified specialist or the Miele Customer Service Department.