Table of Contents
Advertisement
Installation
A stopcock with a ¾" threaded union is
required for the connection. If a stop-
cock is not available, a qualified
plumber should connect the dishwasher
to the mains water supply.
A non-return valve is not required. The
appliance meets the requirements of
the applicable DIN standards.
The water-connection pressure needs
to be between 50 and 1000 kPa. If the
water-connection pressure is too high,
a pressure reducing valve must be fit-
ted.
Risk of damage from leaking wa-
ter.
The connection point is subject to
mains water pressure. Water leaking
from it can cause damage.
You should therefore open the stop-
cock slowly and check for leaks.
Correct the position of the seal and
screw thread if appropriate.
84
Risk of damage due to excessive
pressure.
A brief increase in the water pressure
can damage components of the
dishwasher.
This dishwasher must only be oper-
ated when it is connected to a fully
vented plumbing system.
Risk of electric shock from mains
voltage.
There are electrical components in
the water inlet hose.
The inlet hose must not be shortened
or damaged in any way (see illustra-
tion).
Hide quick links:
Advertisement
Table of Contents
