Download Print this page

DAVIS Vantage Pro ISS Retrofit Kit Instructions Manual page 5

Davis vantage pro iss retrofit kit weather-accessories: install guide
Hide thumbs Also See for Vantage Pro ISS Retrofit Kit:

Advertisement

Install the Retrofit Kit Components
1.
Open the SIM housing cover. Note the "S-loop" in which the TEMP-HUM
cable is formed.
2.
Disconnect the TEMP-HUM cable and close the SIM housing cover.
SIM Housing Cover
UV Sensor
Optional
Solar Radiation
Rain Collector
Anemometer
Temp/Humidity
3.
Place the new SIM housing, radiation sensor plate and Temp/Hum sensor
assembly on the work surface with the SIM housing on the bottom.
4.
Place the two open plates on the Assembly, feeding the TEMP-HUM cable
through the opening in the plates. Be sure that the three screw holes line
up.
Install the Retrofit Kit Components
SIM Housing
Opening the SIM Housing Cover
Cable Routing Channels
(press cables fully into channel
to form "S-loop")
New SIM Connections
1
Use your thumbs to push
back on the two (2) plastic
latches.
2
With the latches pushed
back, use your fingers to
lift up on the corner edges
of the cover.
Screw Fastening Holes.
Use self-threading screws:
#6 x 0.5" (3.5mm x 12 mm)
(optional)
3-Volt Lithium Battery
(wireless models only)
Solar Panel Power
(wireless models only)
AC Power
(optional)
Console Cable
(cabled models
only)
DIP Switches
(wireless models
only)
Page 5

Advertisement

loading
Need help?

Need help?

Do you have a question about the Vantage Pro ISS Retrofit Kit and is the answer not in the manual?

Subscribe to Our Youtube Channel