Table of Contents
Advertisement
Installation Procedure
Step 3 Installing the indoor unit
Before fixing the installation plate to the wall or window
frame, you must determine the position of the 65 mm hole
through which the cable, pipe and hose pass to connect
the indoor unit to the outdoor unit.
When facing the wall, the pipe and cable can be connected
from the:
• Right
• Left
• Underside (right)
• Rear (right or left)
Left
1
Determine the position of the pipe and drain hose
hole as seen in the picture and drill the hole with an
inner diameter of 65 mm so that it slants slightly
downwards.
Plastic anchor
Wall
20 mm
Pipe bundle hole: Ø 65 mm
Model
015/022/028/036
045/056/071
2
If you fix the indoor unit to a wall, fix the installation
plate to the wall giving attention to the weight of the
indoor unit.
NOTE
• If you mount the plate to a concrete wall by using
plastic anchors, make sure that gaps between the wall
and the plate, created by projected anchor, are less
than 20 mm.
6 English
DVM Boracay_IM_EN_DB68-06417A-00_16.09.22.indd 6
Right
Underside
(Unit : mm)
A
B
C
D
30
96
38
30
38
126
70
38
3
If you fix the indoor unit to a window frame, follow
4 to 6.
4
Determine the positions of the wooden uprights to be
attached to the window frame.
5
Attach the wooden uprights to the window frame
giving attention to the weight of the indoor unit.
Attach the installation plate to the wooden uprights
6
using tapping screw.
Step 4 Purging the unit
Upon delivery, there may be inert gas inside the indoor
unit. Purge the gas from the indoor unit before connecting
the assembly pipe.
• Unscrew the caps at the end of each pipe. All inert gas
exhausts from the indoor unit.
NOTE
• To prevent dirt or foreign substances from getting into
the pipes during installation, do NOT remove the caps
completely until you are ready to connect the pipes.
2016/9/22 11:29:11
Advertisement
Table of Contents
