Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for pottery barn kids REMY CRIB
Summary of Contents for pottery barn kids REMY CRIB
- Page 1 pottery barn kids REMY CRIB www.potterybarnkids.com Date: 2015-Aug.-19 Rev: Page 1 of 8 ...
- Page 2 Do not use it if any parts are loose or missing or if there are any signs of damage. Do not substitute parts. Contact Pottery Barn Kids if replacement parts or additional instructions are needed.
- Page 3 CAUTION: ANY MATTRESS USED IN THIS CRIB MUST BE AT LEAST 27 ¼” (69 CENTIMETERS) 5/8” (131 CENTIMETERS) WITH A THICKNESS NOT EXCEEDING 6” (15 CENTIMETERS) THIS CRIB CONFORMS TO APPLICABLE REGULATIONS PROMULGATED BY THE CONSUMER PRODUCT SAFETY COMMISSION. 04-000094-3 IMPORTANT SAFETY INSTRUCTIONS: ...
- Page 4 HARDWARE INCLUDED: (D) Allen key with ball tip (E) Long Allen Bolt (F) Medium Allen Bolt M6 x 45mm - 4x - 1x M6 x 55mm - 4x ( G) Short Allen Bolt (H) Short Bolt (I) Half moon washer M6 x 20mm - 4x M6 x15mm - 8x 1/4”...
- Page 5 ASSEMBLY INSTRUCTIONS: Attach (J&K) to (C). Use Allen Key (D) to tighten as shown below. Note: Make sure the brackets (J&K) point outwards as shown below. J&K Attach (L) to (H). Use Open Wrench (M) and Allen Key (D) to tighten as shown below. ...
- Page 6 Attach (B) to (A) by aligning pre-drill holes with wooden dowels as shown below. Do not fully tighten bolts (E & F) at this time. Arrow sticker side up. Arrow points inside. *Note: The mattress base (C) should be at the highest level (Level 3) when the child is born. It must be at the lowest level (Level 1) before the child can stand up.
- Page 7 5. Attach (A) to (B) by aligning pre-drill holes with wooden dowels as shown below. Do not fully tighten bolts (E & F) at this time. 6. Secure the rest end of (C) to (A) at the same level with another end. Do not fully tighten bolts (G). ...
- Page 8 7. Slowly turn the crib upright. 8. Check alignments and fully tighten all connections at this time. 9. Assembly is now complete. 10. Place the assembly instructions back into the envelope mounted on the mattress base for future reference. CARE INSTRUCTIONS : ...
Need help?
Do you have a question about the REMY CRIB and is the answer not in the manual?
Questions and answers