Operating Heat Pump (With An External Controller); Operating Heat Pump (With An External Flow Switch); Operating Heat Pump (With A Gas Back-Up) - Aquacal TropiCal T035 Operation Manual

Hide thumbs Also See for TropiCal T035:
Table of Contents

Advertisement

1.7.b Operating Heat Pump (With an External Controller)
If the display indicates the unit is under remote
control, an external control device has been
configured to control the heat pump. See the
external control device manual. Or contact
installer or manufacturer of that device.
PLEASE NOTE:
When using a SMART external control device, the time-out and service modes will
deactivate the Heat Pump.
1.7.c Operating Heat Pump (With an External Flow Switch)
When an external flow switch has been installed and enabled, the heat pump will automatically switch from
pool to spa temperature settings when there is flow through the external flow switch. The "Pool/Spa" button
will be disabled when this device is configured in the system.
Confirm with the installer if an external flow switch has been installed on the system.
1.7.d Operating Heat Pump (With a Gas Back-Up)
If a gas backup heater is installed, it will be configured in one of two modes by the installer (Scheduled mode
or 24-hour mode). This affects how the heater operates.
PLEASE NOTE -
Gas backup modes are only available when the ambient air temperature is below 60° F.
See "
Using Gas Boost
Scheduled Mode
When heating the Pool:
The heat pump will operate for one hour. Then a calculation is made on how fast the water temperature is
l
rising (a rate of rise).
If an insufficient amount of time is provided for the heat pump to heat the water, the gas backup heater will
l
be activated.
When the set temperature has been reached, the gas heater will deactivate.
l
The heat pump will continue to maintain the water temperature.
l
When heating the Spa:
If the water temperature is lower than 2° F (-16.7° C) below the set temperature, and the ambient air
l
temperature is below 60° F (15.6° C), the gas heater will activate.
When the set temperature has been reached, the gas heater will deactivate.
l
The heat pump will continue to maintain the water temperature.
l
" on the next page for an exception.
Page - 20

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents